Fuel rails on hart plenum??

[cutch]

Been looking for a billet fuel rail for my hart plenum but I have been reading some nasty stories about them on the sites.

Firstly which one should I use if any? Or should I use my standard rail which doesn't seem to line up correctly with the injector ports ???

If I go for a billet one it seems like most tuners / experienced guys are saying it would be best to use one with the injector clips??

Is this any good??

https://www.ebay.co.uk/ulk/itm/121749190427

[Hall_Effect]

Been looking for a billet fuel rail for my hart plenum but I have been reading some nasty stories about them on the sites.

Firstly which one should I use if any? Or should I use my standard rail which doesn't seem to line up correctly with the injector ports ???

If I go for a billet one it seems like most tuners / experienced guys are saying it would be best to use one with the injector clips??

Is this any good??

https://www.ebay.co.uk/ulk/itm/121749190427

Got mine from Anembo Engineering.
Uses OEM injector clips only down side had to remotely mount the fuel regulator on the inner wing.

http://anembo-engineering.mybigcomme...r-cosworth-yb/

[twin turbo]

With Clips yes, so if it pop up its not splashing fuel all over... but whats Your problem With lining up? you are using the oe runners?

[cutch]

Yes, just looked like it didn't line up correctly. Don't have my spacers for the injectors yet so can't try them properly but I put it on and it looked like they were out of alignment?? Maybe it was my eyes playing tricks on me. Will try it again.