I have dropped my engine in the car yesterday as i need to see where i need to heatproof on the drivers inner wing and bulkhead area, you can see in the photo below where needs doing
![](http://img.photobucket.com/albums/v104/CHICKAROO/MK6%20FIESTA%20JWRC%20COSWORTH%20PROJECT/0f15b7ff.jpg)
And another pic of the engine in showing where manifold is close ect, i may also have to cover the left hand x bar as its very close to the wastegate,
![](http://img.photobucket.com/albums/v104/CHICKAROO/MK6%20FIESTA%20JWRC%20COSWORTH%20PROJECT/IMG_4041_zps9d90207b.jpg)
What i am not sure of though is what to use and what will look best???
I had thought about the Thermo-tec adhesive stuff which is expensive but very good i hear, i have also recently seen alot of people using the gold reflective adhesive backed stuff???
Any ideas please and also how much of the bulkhead do you think i should do and shall i do the full gearbox tunnel as well as obviously the exhaust will run along it
My biggest worry is it looking sh*t![cry](https://www.escortrscosworth.com/forum/core/images/smilies/Bigcry.gif)
Thanks
Marc
![](http://img.photobucket.com/albums/v104/CHICKAROO/MK6%20FIESTA%20JWRC%20COSWORTH%20PROJECT/0f15b7ff.jpg)
And another pic of the engine in showing where manifold is close ect, i may also have to cover the left hand x bar as its very close to the wastegate,
![](http://img.photobucket.com/albums/v104/CHICKAROO/MK6%20FIESTA%20JWRC%20COSWORTH%20PROJECT/IMG_4041_zps9d90207b.jpg)
What i am not sure of though is what to use and what will look best???
I had thought about the Thermo-tec adhesive stuff which is expensive but very good i hear, i have also recently seen alot of people using the gold reflective adhesive backed stuff???
Any ideas please and also how much of the bulkhead do you think i should do and shall i do the full gearbox tunnel as well as obviously the exhaust will run along it
My biggest worry is it looking sh*t
![cry](https://www.escortrscosworth.com/forum/core/images/smilies/Bigcry.gif)
Thanks
Marc
Comment