If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Poly Lactic Acid...thermoplastic. There are a couple of different types you can use for 3D printing.
The melting point is around 150°C ? I’m no expert but it still seems like a practical plastic..?
I’d be interested to see these sanded and properly painted. The guy advertising should have shown a potential finished article...but the ‘raw’ print is good to see, how it layers it up in the print process.
Comment